A |
B |
C |
D |
E |
F |
H |
I |
N |
O |
P |
R |
S |
T |
V |
W |
Keyword:
E
E-grade
stands for electronic upgrade. E-grade can extend the functionality of the CC-Pilot. A unit specific activation code is required. This can be carried out in the factory. If ordered at a later date the activation code can be sent by E-Mail.
Extended Working Temperature Range
Extended Working Temperature Range is the temperature range that can be attained when using a factory-fitted cooling coil when operating with cooling water.
External Control
Often cascade control, is when the temperature control is dictated by the temperature of the connected external application. A temperature sensor (often a Pt100 4 wire configuration with a Lemosa plug) is therefore required in the extemal application, which is connected to the thermostat. The actual value measured at the external application is measured and a set point for the thermostat is continually calculated. Depending on the operating temperature, insulation losses and exothermic ractions, the bath temperature and thus the flow temperature of the thermostat can be considerably above or below the set point. (Always consider the safety limits of the fluid!!)
